Lines Matching full:parallel

2 Linux and parallel port IDE devices
10 Owing to the simplicity and near universality of the parallel port interface
12 CD-ROM, LS-120 and tape drives use the parallel port to connect to their
14 to pass commands and data through the parallel port interface, most
16 a parallel-port adapter chip added in.  Some of the original parallel port
23 the device being addressed via the parallel cable is a standard SCSI
27 of external parallel port devices, however, are now based on standard
29 were to open up a parallel port CD-ROM drive, for instance, one would
31 that interconnected a standard PC parallel port cable and a standard
35 The document describes the support in Linux for parallel port IDE
36 devices.  It does not cover parallel port SCSI devices, "ditto" tape
38 parallel port IDE subsystem, including:
54 To support such a wide range of devices, PARIDE, the parallel port IDE
57 accessing the parallel ports.  The second component is a set of
72 for each of the parallel port IDE adapter chips.  Thanks to the interest
100 In either case, you will need to select "Parallel port IDE device support"
102 of the parallel port communication protocols.  If you do not know
103 what kind of parallel port adapter is used in your drive, you could
140 and you have just a single parallel port IDE device, your kernel should
147 By default, each driver will automatically try all parallel ports it
149 a parallel port IDE adapter.  Once it finds one, the probe stops.  So,
171 with unit ID number 36 connected to the parallel port at 0x378, a SyQuest
179 is the parallel port base address, the 0 is the protocol registration
183 PARPORT parallel port sharing system that is included by the
184 "Parallel port support" option, PARPORT must be included and enabled
185 if you want to use chains of devices on the same parallel port.
315 The pf driver is intended for use with parallel port ATAPI disk
324 The pt driver for parallel port ATAPI tape drives is a minimal driver.
327 probably want to set the parallel port delay to 0, if you can.
335 your parallel port should ideally be set to EPP mode, and the "port delay"
348 concern the parallel port CMOS settings.  At this time, none of the
350 If you are able to do so, please set your parallel port into EPP mode
356 Some parallel ports cannot reliably transfer data at full speed.  To
376 the parallel port.  As the reset operation is potentially disruptive in
396 is using your parallel port (check in /proc/ioports).  Then, load the