Lines Matching +full:led +full:- +full:controller
1 What: /sys/class/leds/<led>/flash_brightness
6 Set the brightness of this LED in the flash strobe mode, in
7 microamperes. The file is created only for the flash LED devices
11 /sys/class/leds/<led>/max_flash_brightness.
13 What: /sys/class/leds/<led>/max_flash_brightness
18 Maximum brightness level for this LED in the flash strobe mode,
21 What: /sys/class/leds/<led>/flash_timeout
28 of the strobe. The file is created only for the flash LED
31 What: /sys/class/leds/<led>/max_flash_timeout
36 Maximum flash timeout for this LED, in microseconds.
38 What: /sys/class/leds/<led>/flash_strobe
49 What: /sys/class/leds/<led>/flash_fault
55 Flash faults are re-read after strobing the flash. Possible
58 * led-over-voltage
59 flash controller voltage to the flash LED
60 has exceeded the limit specific to the flash controller
61 * flash-timeout-exceeded
65 * controller-over-temperature
66 the flash controller has
68 * controller-short-circuit
70 of the flash controller has been triggered
71 * led-power-supply-over-current
72 current in the LED power
74 controller
75 * indicator-led-fault
76 the flash controller has detected
77 a short or open circuit condition on the indicator LED
78 * led-under-voltage
79 flash controller voltage to the flash
80 LED has been below the minimum limit specific to
82 * controller-under-voltage
84 controller is below the limit under which strobing the
87 * led-over-temperature
88 the temperature of the LED has exceeded