1312 	struct device *hub_dev = hub->intfdev;  in hub_configure()  local
1380 	dev_info(hub_dev, "%d port%s detected\n", maxchild,  in hub_configure()
1408 		dev_dbg(hub_dev, "compound device; port removable status: %s\n", portstr);  in hub_configure()
1410 		dev_dbg(hub_dev, "standalone hub\n");  in hub_configure()
1414 		dev_dbg(hub_dev, "ganged power switching\n");  in hub_configure()
1417 		dev_dbg(hub_dev, "individual port power switching\n");  in hub_configure()
1421 		dev_dbg(hub_dev, "no power switching (usb 1.0)\n");  in hub_configure()
1427 		dev_dbg(hub_dev, "global over-current protection\n");  in hub_configure()
1430 		dev_dbg(hub_dev, "individual port over-current protection\n");  in hub_configure()
1434 		dev_dbg(hub_dev, "no over-current protection\n");  in hub_configure()
1445 		dev_dbg(hub_dev, "Single TT\n");  in hub_configure()
1451 			dev_dbg(hub_dev, "TT per port\n");  in hub_configure()
1454 			dev_err(hub_dev, "Using single TT (err %d)\n",  in hub_configure()
1462 		dev_dbg(hub_dev, "Unrecognized hub protocol %d\n",  in hub_configure()
1472 			dev_dbg(hub_dev, "TT requires at most %d "  in hub_configure()
1479 		dev_dbg(hub_dev, "TT requires at most %d "  in hub_configure()
1485 		dev_dbg(hub_dev, "TT requires at most %d "  in hub_configure()
1491 		dev_dbg(hub_dev, "TT requires at most %d "  in hub_configure()
1500 		dev_dbg(hub_dev, "Port indicators are supported\n");  in hub_configure()
1503 	dev_dbg(hub_dev, "power on to power good time: %dms\n",  in hub_configure()
1530 		dev_dbg(hub_dev, "hub controller current requirement: %dmA\n",  in hub_configure()
1535 			dev_warn(hub_dev,  in hub_configure()
1546 		dev_dbg(hub_dev, "%umA bus power budget for each child\n",  in hub_configure()
1557 		dev_dbg(hub_dev, "local power source is %s\n",  in hub_configure()
1562 		dev_dbg(hub_dev, "%sover-current condition exists\n",  in hub_configure()
1628 	dev_err(hub_dev, "config failed, %s (err %d)\n",  in hub_configure()
5262 	struct device *hub_dev;  in hub_event()  local
5269 	hub_dev = hub->intfdev;  in hub_event()
5270 	intf = to_usb_interface(hub_dev);  in hub_event()
5272 	dev_dbg(hub_dev, "state %d ports %d chg %04x evt %04x\n",  in hub_event()
5294 		dev_dbg(hub_dev, "Can't autoresume: %d\n", ret);  in hub_event()
5303 		dev_dbg(hub_dev, "resetting for error %d\n", hub->error);  in hub_event()
5307 			dev_dbg(hub_dev, "error resetting hub: %d\n", ret);  in hub_event()
5344 		dev_err(hub_dev, "get_hub_status failed\n");  in hub_event()
5347 			dev_dbg(hub_dev, "power change\n");  in hub_event()
5359 			dev_dbg(hub_dev, "over-current change\n");  in hub_event()
5365 				dev_err(hub_dev, "over-current condition\n");  in hub_event()