Lines Matching refs:temperature
39 The driver implements three temperature sensors, seven fan rotation speed
55 the temperature gets higher than the Overtemperature Shutdown value; it stays
56 on until the temperature falls below the Hysteresis value.
96 Tart will be asserted while target temperature cannot be achieved after 3 minutes
136 range. At first a wanted temperature and interval must be set. This is done
138 interval. The fan speed will be lowered as long as the current temperature
139 remains below the thermal_cruise# +- tolerance# value. Once the temperature
142 with the temperature varying. Three conditions may occur:
144 (1) If the temperature still exceeds the high limit, PWM duty
147 (2) If the temperature goes below the high limit, but still above the low
149 the temperature is in the target range.
151 (3) If the temperature goes below the low limit, PWM duty cycle will decrease
152 slowly to 0 or a preset stop value until the temperature exceeds the low
158 W83792D also provides a special mode for fan. Four temperature points are
159 available. When related temperature sensors detects the temperature in preset
160 temperature region (sf2_point@_fan# +- tolerance#) it will cause fans to run
170 pwm[1-3]_enable - this file controls mode of fan/temperature control:
178 thermal_cruise[1-3] - Selects the desired temperature for cruise (degC)
180 sf2_point[1-4]_fan[1-3] - four temperature points for each fan for Smart Fan II