Lines Matching refs:temperature

57 The chips support up to 25 temperature monitoring sources. Up to 6 of those are
58 direct temperature sensor inputs, the others are special sources such as PECI,
59 PCH, and SMBUS. Depending on the chip type, 2 to 6 of the temperature sources
66 The temperature sensor sources on all chips are configurable. The configured
67 source for each of the temperature sensors is provided in tempX_label.
70 either 1 degC or 0.5 degC, depending on the temperature source and
71 configuration. An alarm is triggered when the temperature gets higher than
72 the high limit; it stays on until the temperature falls below the hysteresis
90 In this mode, the chip attempts to keep the measured temperature in a
91 predefined temperature range. If the temperature goes out of range, fan
102 pwm[1-7]_enable - this file controls mode of fan/temperature control:
117 pwm[1-7]_temp_sel	Temperature source. Value is temperature sensor index.
120 			Secondary temperature source. Value is temperature
122 			Set to 0 to disable secondary temperature control.
124 If secondary temperature functionality is enabled, it is controlled with the
134 			Temperature at which secondary temperature control kicks
142 If the temperature is in the range defined by:
144 pwm[1-7]_target_temp	Target temperature, unit millidegree Celsius
147 			Target temperature tolerance, unit millidegree Celsius
149 there are no changes to fan speed. Once the temperature leaves the interval, fan
150 speed increases (if temperature is higher that desired) or decreases (if
151 temperature is lower than desired), using the following limits and time
155 			when the temperature is above defined range.
156 pwm[1-7]_floor		lowest fan pwm (range 0 - 255) if temperature is below
158 			stop if the temperature is below the defined range.
162 			corresponding fan off (when the temperature was below
181 controlled by setting the pwm and temperature attributes. When the temperature
185 higher fan speeds with increasing temperature. The last data point reflects
186 critical temperature mode, in which the fans should run at full speed.
189 			pwm value to be set if temperature reaches matching
190 			temperature range.
196 			Temperature tolerance for critical temperature,
207 temperature measurement device. As a result, the temperature reported on CPUTIN
209 temperatures, and in some cases the reported temperature declines if the actual
210 temperature increases (similar to the raw PECI temperature value - see PECI
212 boards. The CPU temperature on ASUS boards is reported from PECI 0.